Pull on the end of the exposed core as you massage the junction of the core to cover the joint.ġ0. This creates a neat splice with a taper.ĩ. Starting about 4 inches from the end, use a small fid to pull out about 8–10 random strands from the cover before trimming them off with scissors. Work it down one complete fid length before pulling it out of the core.Ĩ. Now, wedge the end of the cover into the fid, then feed it into the core at the second mark. Make sure that both sections of core are not snagged on one another and freely move within the core.ħ. Pull about 6 inches of the core out of the hole. Work the fid down so that it exits the cover 1 to 2 inches past where the core exits.Ħ. Wedge the end of the core into the hollow end of a fid that matches the diameter of the core, then push the fid into the cover at the first mark. That's where you will be inserting the cover into the core.ĥ. Mark the core where it comes out of the cover (your third mark), then pull out a couple feet more and place a fourth mark on the core two-thirds of a fid length from the one you just made. (If the end of the line was melted when it was originally cut to length, trim this off with a sharp knife so the core moves freely.) Lay the cord and the cover alongside each other.Ĥ. Using a small fid, separate the strands of the cover at the second mark and pull out the core. Form a loop or eye to the desired size then place a second mark opposite the first.ģ. Make a mark on the line one fid-length from the end.Ģ. Tie a slipknot about 15 feet from the end of the line, and loop it over a winch or cleat to hold it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |